Large machinery cannot be rotated manually, so the power is cut off immediately after the start of the no-load, the machine is idling, and the presence or absence of vibration, noise, and contact of the rotating parts is checked. After confirming that there is no abnormality, the power is turned on.
The power running starts from the no-load low speed and slowly increases to the rated operation of the specified conditions. The items to be checked during the test run are whether there is abnormal sound, change in the temperature of the self-aligning ball bearing, leakage or discoloration of the lubricant, and the like. If an abnormality is found, stop the operation immediately, check the machine, and remove the bearing check if necessary.
TIMKEN bearing temperature can generally be estimated based on the external temperature of the bearing housing. However, it is more accurate to directly measure the temperature of the outer ring of the bearing by using the oil hole. The bearing temperature gradually rises from the start of the operation, and the temperature is usually stable after 1 to 2 hours. If the bearing is poorly installed, the temperature will rise sharply and an abnormally high temperature will occur. The reasons are such as excessive lubricant, too small bearing clearance, poor installation, excessive friction of the sealing device, and the like. In the case of high-speed rotation, the selection of TIMKEN bearing structure and lubrication method is also the cause.
The rotation sound of TIMKEN bearings is checked with a stethoscope, etc., and there are strong metal noise, abnormal sounds, irregular sounds, etc. to explain abnormalities. The reasons are poor lubrication, poor accuracy of the shaft or housing, bearing damage, and foreign matter intrusion.
The surface of the steel under transient high temperature acts on the oxygen in the air and rises into a very thin (20-30 nm) thin layer of iron oxide. It is worth noting that the thickness of the oxide layer is corresponding to the test results of the total thickness of the surface-grinding metamorphic layer. This shows that the thickness of the oxide layer is directly related to the grinding process and is an important indicator of the quality of the grinding.
1. First of all, you must buy a real self-aligning ball bearing. If you buy a fake bearing, you can't live longer.
2. Before installing the bearing, first check whether the bearing is short of oil, whether it is clean, and then check the parts to be installed, determine the grease and clean, and install the bearing correctly.
3, the bearing trial, after the installation, the bearing trial operation, running for a while to check no abnormalities, this bearing can be normally used.
4, to check regularly, the lubrication of each type of TIMKEN bearing is essential, the bearing is no exception, when maintaining the bearing, first check the bearing surface is clean, if not clean enough, then use gasoline or alcohol first Rinse it again, then the crucial part is the grease. When grease is applied to the bearing, do not add too much grease. Just rub a little grease to rub between the two. If there is any pollutant, it can be felt. When using grease for self-aligning ball bearings, avoid contact with any part of the bearing with the cotton fabric, which may cause some residual fibers to roll and cause damage. It is best to determine the time of each inspection, and then check whether the lack of oil is clean according to the normal time. Doing so can make the life of the self-aligning ball bearing longevity.
For more information and purchase please visit: https://www.supplyforever.com
