Many customers have increased the working frequency and duration of the engraving machine because of the increase in orders. If the daily maintenance of the engraving machine is not taken seriously, it will not be worth the effort to affect the production progress when the machine fails! As a professional engraving machine manufacturer, the engineers of Engraving Machine Intelligent Equipment Co., Ltd. give you some advice on the maintenance of engraving machine, hoping to help you with friends in need:
First, the stone engraving machine selects smooth, oil and butter mixture, not too thick.
Second, the smooth process of the stone engraving machine: Before the smoothing, the impurities on the lead screw, the wire on the guide rail and the inside of the bearing are removed. If it is difficult to clean, it can be assisted by gasoline, then write the smooth oil and then gradually increase the speed. Empty, that is, no plate, three-axis running-in.
Third, the stone engraving machine lubrication part: x.y.z three-axis screw. Light bar.
Fourth, the smooth cycle of the stone engraving machine: depending on the working environment and duration of the machine, generally the slag is cleaned off after work every day. Each part is regularly refueled every month, and the high-speed air is smooth.
Fifth, the smooth method of the three-axis stone carving machine:
Y-axis: smooth and simple, the two sides of the guide rail are relatively simple to sort and oil, and the bottom screw can also enter the oil from the bracket, which is relatively easy to protect.
X-axis: need to remove the screws before and after, lift a shield (note: the line on the left side of the side panel should be relaxed and then lifted), the right side is completely lifted and the mixed oil is injected into the guide rail, screw, bearing and right. The thrust bearing of the side screw head.
Z-axis: Open the shroud, the lead screw, the guide rail, and the thrust bearing at the bottom of the bearing. It can be seen at a glance, and then the mixed oil should be smoothed up and down.
While smoothing the three axes, the inner hexagonal screws on the coupling between the motor shaft and the screw head can be tightened by the inner hexagonal wrench to prevent the three shafts from being misaligned due to some looseness of the machine.
As for the protection of other parts of the stone engraving machine, such as pumps. Cutting the spindle, the two are mutual, always replace the circulating water, adhere to the water and water temperature to block the water pump outlet or the water-cooled cutting spindle works at high temperature to form component damage.
Many people are tired and will say that people are not machines. In fact, the machines will be tired. It is also necessary to rest and maintain. The well-maintained engraving machine can maximize the efficiency and stability of production, and the production will be more effective.
