First, the stone engraving machine machine does not return to zero after the completion of the processing
1. Is the limit switch connected, and the limit switch is damaged?
2. Is the Weihong card damaged?
3. Is the parameter in the DSP handle correct?
4. Check the drawing file problem
5. After the sculpture is finished, Weihong presses the F7 key and the DSP confirms whether it can return to the origin.
Second, the spindle does not reach the specified speed
1. Check if the wiring on the inverter and the terminal block is correct.
2. Re-adjust the internal parameters of the inverter
3. Weihong card data line terminal block is damaged. The parameters in the DSP controller are incorrectly reset.
Third, the square is not square, the circle is not round, there is a sawtooth in the middle of the jitter
1. Adjust the parallelism of the machine, check the slider, motor belt, coupling, loose and damaged
2. Adjust the three-point concentricity tightness of the motor base of each shaft bearing housing of the machine tool.
Fourth, the misplacement in the sculpture
1. Check whether the shaft of the machine is lubricated
2. Is the speed too fast? Is the parameter set correctly?
3. Is there any static electricity or external interference, is there a ground wire?
4.X Y Z On each axis of the motor, the motor seat wire base bearing seat is in the same state of concentricity.
5. The drive current is too small and the motor or drive is damaged.
5. No response during startup, no power to the machine, no response to the handle, no display
1. Reinstall the software in the position of the Weihong card slot in the computer case.
2. Does the DSP handle data connection line have a pinch phenomenon?
3. Check the power supply output current in the control box, whether the line on the terminal block is correct, whether the aviation plug is connected correctly.
4 drive total electrical switch fuse rectifier is damaged
Six: the nose can not be returned to zero and the engraving machine is reduced or out of bounds
1. The machine head cannot be returned to the zero position, the lead screw may be misaligned, and the lead screw needs to be adjusted.
2. The stroke switch is damaged
3. The machine can not be returned to zero and the engraving machine is reduced or out of bounded. It may be that the "model" in the machine setting does not match the actual model.
